4/11/2024 0 Comments Long path tool 5.1.4 license key![]() The zoning-rule entries that matched the previous pctag as the source and EPG1 and EPG2 as the destination do not get reprogrammed and they remain in a stale status in the table. If a service graph gets attached to the inter-VRF contract after it was already attached to the intra-VRF contract, the pctag for the shadow EPG gets reprogrammed with a global value. In the case of a new MDP spine node, the traffic might not get directed to the new spine node. In a setup where there is already existing MDP confguration (spine and leaf nodes), after having deleted an MDP spine node, MDP tunnels and traffic might still be directed to that spine node. ![]() The SPAN configuration is pushed to the anchor or non-anchor nodes, but the interfaces are not pushed due to the following fault: "Failed to configure SPAN with source SpanF元out due to Source fvIfConn not available". Support for local user (admin) maximum tries and login delay configuration.Ī bridge domain route is not leaked on the service ToR switch after re-triggering the service graph.Īll the external prefixes from VRF-A could be leaked to VRF-C even when an inter-VRF ESG leak route is configured for a specific prefix.Ī SPAN session with the source type set to "Routed-Outside" goes down. A bug might also exist in releases other than the 5.1(4) releases.įor strict security requirements, customers require custom certificates that have RSA key lengths of 30. The "Exists In" column of the table specifies the 5.1(4) releases in which the bug exists. There are no changes in behavior in this release.Ĭlick the bug ID to access the Bug Search tool and see additional information about the bug. You can configure the deny action in the route-map for interleak redistribution for static routes and direct subnets.įor the new hardware features, see the Cisco Nexus 9000 ACI-Mode Switches Release Notes, Release 15.1(4). You can also configure the deny action in the route-map for interleak redistribution for static routes and direct subnets.įor more information, see the Cisco APIC Layer 3 Networking Configuration Guide, Release 5.1(x).ĭeny action in the route map for interleak redistribution for static routes and direct subnets You can apply a route map to interleak redistribution from direct subnets (元Out interfaces). ![]() Applying a route map to interleak redistribution from direct subnets ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |